Panasonic BT-LT1700 - Manual (Page 9)

17
g WB adjustment mode
You can adjust “WHITE BALANCE VAR1” – “WHITE BALANCE VAR3” (WB) by selecting “VAR1” – “VAR3” in
“COLOR TEMP.” in the “VIDEO CONFIG” menu.
The underlined values are factory preset setting values.
*1 When adjusting, the item display moves to the lower part of the screen.
The underlined values are factory preset setting values.
*2 This function is disabled while in 2 screen display mode.
*3 These functions are disabled when the control settings are in GPI mode.
*4 If these settings are changed, the menu settings will also change.
*5 When “RGB-COMP.” is not selected in “YP
B
P
R
/RGB” in the “INPUT SELECT” menu, “NOT RGB-COMP.CH-” is
displayed, and this does not operate.
*6 This function will not work when “RGB-COMP.” is selected in “YP
B
P
R
/RGB” in the “INPUT SELECT” menu.
Sub menu Settings Explanation
COLOR TEMP. Used to select the color temperature that will become the
basis for adjustments.
Adjustable settings 0–63 (color
temperature around 3000K–9300K)
Color temperature around 9300K
Color temperature around 6500K
Color temperature around 5600K
WB-HIGH RED <0–60>
(Factory preset settings: 30) Used to adjust the WB in the HIGH level R component.
*1
WB-HIGH GREEN Used to adjust the WB in the HIGH level G component.
*1
WB-HIGH BLUE Used to adjust the WB in the HIGH level B component.
*1
WB-LOW RED Used to adjust the WB in the LOW level R component.
*1
WB-LOW GREEN Used to adjust the WB in the LOW level G component.
*1
WB-LOW BLUE Used to adjust the WB in the LOW level B component.
*1
RESET This returns the “WB-HIGH RED” – ”WB-LOW BLUE”
settings to the factory presets.
SYSTEM CONFIG
Sub menu Settings Explanation
BACKLIGHT < 0–60 > Used to adjust the brightness of the liquid crystal backlight.
FUNCTION1
SELECT>
WINDOW>
Used to select the functions assigned to [FUNCTION1] and
[FUNCTION2] (front buttons).
*2
Displays the synchronizing signal (horizontal, vertical).
The display is switched in the following order.
OFF
J H-Delay J V-Delay J HV-Delay J OFF
*5
Used to automatically adjust the PC display.
Used to cut the red and green signals. You can check the hue (PHASE)
and depth of color (CHROMA). This is switched between ON/OFF by
pushing the button.
You can switch between “NORMAL” and “FILM”.
*3*4
Used to switch between “16:9” and “4:3”.
*3*4
You can switch between “UNDER” and “NORMAL”.
*3*4
You can perform the settings for 2 screen display mode.
*3*4*6
No settings
FUNCTION2
SELECT>
WINDOW>
Main Menu
(continued)