ProForm PFEL04907.0 - Manual (Page 5)

5
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M8 x 50mm Button
Screw (65)–2
M8 x 35mm Button
Bolt (67)–4
M10 x 20mm Button
Screw (58)–4
M10 x 25mm
Washer (52)–4
M8 x 16mm Button
Screw (53)–5
M8 Nylon
Locknut (68)–4
19mm Wave
Washer (71)–4
M8 x 25mm Button
Screw (77)–6
16mm Wave
Washer (66)–4
M8 x 25mm
Washer (54)–8
M4 x 19mm
Screw (75)–4
M4 x 35mm
Screw (74)–2
M4 x 50mm
Screw (76)–4
M10 x 35mm Shoulder
Screw (57)–2