beautypg.com

Operating instructions, Helpful tip, Warning – Poulan Pro PP2822 User Manual

Page 5

background image

-- 5 --

components, etc. Alternative fuels cause high

moisture absorption into the fuel/oil mixture

leading to oil and fuel separation.

OPERATING INSTRUCTIONS

It is recommended that the engine not be

The HANDLE LEVER can be used to rotate

the rear handle to allow operation of the unit

at a 45

o

and 90

o

position.

To rotate rear handle:

operated for longer than 30 seconds at full

throttle. Releasing the trigger and allowing

the engine to briefly return to idle speed (5 --

10 seconds) will be sufficient.

IMPORTANT POINTS

Use the minimum throttle speed necessary

to effectively cut hedges for optimal hedge

trimmer performance.

Never attempt to use this hedge trimmer to

cut hedges that have any branches with a

diameter larger than 1 ″ (2.54 cm).

OPERATING POSITION

Eye

Protection

Hearing

Protection

STOPPING YOUR ENGINE

HANDLE LEVER

To stop the engine, move the ON/OFF

switch to the OFF position.

If engine does not stop, move choke lever

to the FULL CHOKE position.

STARTING YOUR ENGINE

Fuel engine. Move at least 10 feet (3 me-

ters) away from the fueling site.

Remove the blade cover from the blade

before starting the unit.

Hold the unit on the ground in the starting

position as shown. Support unit so the

blade is off of the ground and away from

trees, bushes, onlookers, etc.

HELPFUL TIP

If your engine still does not

start after following these

instructions, please call

1--800--554--6723.

STARTING A COLD ENGINE (or a

warm engine after running out of

fuel)

WARNING:

The cutting blade will be

moving once the engine starts. Wear your

protective equipment and observe all safety

WARNING:

During operation, hold

the unit with the muffler exhaust away from

your body and clothes.

instructions.

Throttle Lock-out

Throttle

Trigger

ON/OFF

Switch

1. Move the ON/OFF switch to the ON posi-

1. Allow engine to return to idle speed.

3. Release handle lever.

2. Pull handle lever and rotate rear handle to

desired position.

tion.

2. Slowly press the primer bulb 10 times.

3. Move the choke lever to the FULL CHOKE

position.

Choke Lever

Primer Bulb

4. Pull starter rope handle sharply until en-

gine sounds as if it is trying to run, but do

not pull rope more than 3 times.

Handle Lever

Rear Handle