beautypg.com

Operation, Warning, Helpful tip – Poulan Pro PP2822 User Manual

Page 4

background image

-- 4 --

OPERATION

KNOW YOUR HEDGE TRIMMER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR

UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the vari-

ous controls and adjustments. Save this manual for future reference.

Muffler

Throttle

Trigger

ON/OFF

Switch

Throttle

Lock--out

Primer Bulb

Starter Rope

Choke Lever

Fuel Mix

Fill Cap

ON/OFF SWITCH

FRONT HANDLE AND REAR

HANDLE

The ON/OFF SWITCH is used to stop the en-

gine. To stop engine, move switch to OFF.

CHOKE

The CHOKE helps to supply fuel to the engine

The FRONT HANDLE and REAR HANDLE

are used to maintain control of the unit.

HANDLE LEVER

The HANDLE LEVER can be used to rotate

the rear handle to allow operation of the unit

at a 45

o

and 90

o

position.

to aid in cold starting. Activate the choke by

moving choke lever to the desired position. See

STARTING YOUR ENGINE for complete start-

ing information.

PRIMER BULB

The PRIMER BULB removes air from the car-

buretor and fuel lines and fills them with fuel.

This allows you to start the engine with fewer

pulls on the starter rope. Activate the primer

bulb by pressing it and allowing it to return to

its original position.

THROTTLE TRIGGER

The THROTTLE TRIGGER controls engine

speed. Squeeze the trigger for full speed opera-

tion; release it for idle speed.

WARNING:

Muffler is very hot during

and after use. Do not touch the muffler or al-

low combustible material such as dry grass or

fuel to do so.

BEFORE STARTING ENGINE

WARNING:

Be sure to read the fuel

information in the safety rules before you be-

gin. If you do not understand the safety rules,

do not attempt to fuel your unit. Call

1-800-554-6723.

FUELING ENGINE

WARNING:

Remove fuel cap slowly

when refueling.

HELPFUL TIP

To obtain the correct oil mix

ratio, pour 3.2 ounces of

2--cycle synthetic oil into

one gallon of fresh gas.

This engine is certified to operate on unleaded

gasoline. Before operation, gasoline must be

mixed with a good quality synthetic 2-cycle air-

cooled engine oil designed to be mixed at a ratio

of 40:1. Poulan/WEED EATER brand synthetic

oil is recommended. A 40:1 ratio is obtained by

mixing 3.2 fluid ounces (95 ml) of oil with 1 gallon

(4 liters) of unleaded gasoline). DO NOT USE

automotive oil or boat oil. These oils will cause

engine damage. When mixing fuel, follow

instructions printed on oil container. Once oil is

added to gasoline, shake container momentarily

to assure that the fuel is thoroughly mixed. Al-

ways read and follow the safety rules listed un-

der HANDLE FUEL WITH CAUTION.

CAUTION:

Never use straight gasoline in

your unit. This will cause permanent engine

damage and void the limited warranty.

FUEL REQUIREMENTS

This engine requires the use of minimum 87

octane [R+M]/2 clean gasoline.

IMPORTANT

Use of alcohol blended fuels (called gasohol or

using ethanol or methanol) can cause major en-

gine performance and durability problems.

WARNING:

Alternative fuels (not gas-

oline) such as E--15 (15% alcohol), E--20 (20%

alcohol), E--85 (85% alcohol) are NOT classified

as gasoline and are NOT approved for use in

2--stroke gasoline engines. Use of alternative

fuels will cause problems such as: improper

clutch engagements, overheating, vapor lock,

power loss, lubrication deficiency, deterioration

of fuel lines, gaskets and internal carburetor

Spark Plug

Rear

Handle

Hand Guard

Front Handle

Blade

Cover

Handle

Lever

Grease Nozzle

(not serviceable)