Pioneer AVIC-N1 - Manual (Page 16)

14
Chapter 1
How to Use Navigation Unit and Names of the Parts
❒ If the DVD drive does not operate properly, an
error message such as ERROR-11 may be
displayed.
➲ Error messages ➞ Operation Manual
Adjusting the volume
• Use VOLUME to adjust the audio sound
level.
With this product, rotate VOLUME to
increase or decrease the volume.
Please refer to save volume level instructions
on page 1 of this manual.
❒ To adjust the navigation volume, go to the
navigation menu.
➲ Navigation volume adjustment ➞ Opera-
tion Manual
Turning the source off
• Press SRC button and hold until the
source turns off.
❒ This product can be switched off by turn-
ing the ACC (ignition) OFF or detaching
the front panel.
Using the REAR button
You can output the sound and video of the disc in
the built-in DVD drive to the rear display regard-
less of whether DVD drive is selected as the
source or not (REAR ON mode).
• When you have turned the REAR ON mode
on by pressing REAR button, you cannot
turn it off even if you press SRC button
and hold. In this case, press REAR button
to turn the REAR ON mode off.
• Press REAR button to turn the REAR ON
mode.
The sound and video are outputted to the rear
display and the illumination color of REAR
button changes to red.
❒ To turn the REAR ON mode off, press
REAR button again.
❒ When a CD or CD-ROM is inserted, sound
only is output to the rear display.
➲ Selecting the video of rear display ➞ Opera-
tion Manual
Opening and closing the LCD
panel
• Do not close the LCD panel with hands by
force. That cause malfunction.
The LCD panel will be opened or closed automati-
cally with the turning of the ignition switch on or
off. You can turn off the automatic close/open
function.
➲ Setting close/open function ➞ Operation
Manual
• The automatic close/open function will operate
the display as follows.
— When the ignition switch is turned OFF
while the LCD panel is open, the LCD panel
will close after six seconds.
— When the ignition switch is turned ON
again (or turned to ACC), the LCD panel will
open automatically.
— Removing or attaching the front panel will
automatically close or open the LCD panel.
➲ Removing the front panel ➞ Page 17
• When the ignition switch is turned OFF after
the LCD panel has been closed, turning the
ignition switch ON again (or turning it to ACC)
will not open the LCD panel. In this case, press
OPEN/CLOSE button to open the LCD panel.
• When closing the LCD panel, check to make
sure that it has closed completely. If the LCD
panel has stopped halfway, leaving it like this
could result in damage.
• Press OPEN/CLOSE button to open the
LCD panel.
❒ To close the LCD panel, press OPEN/
CLOSE button again.