beautypg.com

Power source, Important: raising and lowering the lid, Protect your furniture – PYLE Audio PNGTT1 User Manual

Page 4

background image

3

Remove the opaque white plastic stylus

cover from the phonograph stylus by

sliding it in the direction of the arrow.

Discard the stylus cover.

Remove the twist-tie that was used to

secure the tone arm during shipment.

Release the tone arm lock lever.

Connect the plug to your AC outlet.

STYLUS COVER

TONE ARM LOCK LEVER

POWER SOURCE

This product is designed to operate on 120V 60Hz AC only. Attempting to
operate this system from any other power source may cause damage to the
system, and such damage is not covered by your warranty.

NOTE: You will note that this system is equipped with domestic standard AC
power 2-pin plug. If this plug does not fit into your
existing AC outlet, do not try to defeat this safety
feature by filing the wide blade to make it fit into
your outlet. If this plug will not fit into your outlet,
you probably have an outdated non-polarized AC
outlet. You should have your outlet changed by a
qualified licensed electrician.

IMPORTANT: Raising And Lowering The Lid

To open the lid, raise it as far as it will go until the lid support bracket ‘locks’ in

the open position. To close the lid, lift it upward slightly until the lid support

bracket ‘unlocks’ , and then gently lower the lid.

TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID CLOSED.
ALWAYS RAISE THE LID TO RELEASE THE LID SUPPORT BRACKET.

PROTECT YOUR FURNITURE

This model is equipped with non-skid rubber ‘feet’ to prevent the product from
moving when you operate the controls. These‘feet’are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on
your furniture. However certain types of oil based furniture polishes, wood
preservatives, or cleaning sprays may cause the rubber ‘feet’ to soften, and
leave marks or a rubber residue on the furniture. To prevent any damage to your
furniture we strongly recommend that you purchase small self-adhesive felt
pads, available at hardware stores and home improvement centres everywhere,
and apply these pads to the bottom of the rubber ‘feet’ before you place the
product on fine wooden furniture.

AC Outlet

AC Plug