PYLE Audio PNGTT1 - Manual (Page 16)

THE TURNTABLE DRIVE BELT IS FACTORY FITTED –
USE THESE INSTRUCTIONS ONLY IF THE TURNTABLE
FAILS TO REVOLVE
....
THE TURNTABLE DRIVE BELT IS FACTORY FITTED –
USE THESE INSTRUCTIONS ONLY IF THE TURNTABLE
FAILS TO REVOLVE
....
S T E P 1
S T E P
2
S T E P
2
S T E P
3
S T E P
3
S T E P 4
Use a screwdriver to remove the black iron C-clip and lift
the turntable off the phonograph mechanism.
Retrieve the dropped black rubber turntable drive belt
and replace it around the column on the bottom of the
turntable, then pull it out gently without overstretching
and hook the band around the small column point at the
edge of the turntable, as shown in the diagram.
To fix the turntable back onto the phonograph mechanism,
make sure the column point is positioned over the correct
place on the phonograph mechanism, while placing the
axis of the turntable in the hole on the phonograph
mechanism, as shown in the diagram.
Gently turn the turntable until a ‘pop’ sound is heard,
which indicates the repositioning of the rubber band.
Replace the C-clip to secure the turntable.
15