PYLE Audio PWMA110 - Manual (Page 2)

1
2
3
4
5
6
7
8 9 10 11 12 13 14
POWER W/MIC MIC CD IN TREBLE BASS
ECHO MIC CD IN REC OUT
PL R F
1. Antenna: to receive signal
from wireless transmitter
2. Power switch
3. ECHO control
4. MIC input jack
5. AUDIO input jack
6. Speaker
7. Recording signal output
8. BASS control
9. TREBLE control
10. Audio Input volume control
11. Wired MIC volume control
12. Wireless microphone volume
control
13. RF LED indicator of
wireless microphone
14. Power LED indicator
CAUTION
PARTS DESCRIPTION
1. Keep this device away from high temperature. Don't
expose this device to direct sunshine or near the hot
equipment.
2. Don't place the device in the environment of humidity and
dirts.
3. Place the device in the ventilated environment.
4. Don't pull the power cord while unplug the device. Please
hold he plug to unplug.
5. Unplug the device from mains power supply if you will not
use the device for a long time.
6. Your operation must be subjected to the specified
voltage marked on the device and complied with this
manual.
7. Don't open chassis! It is very dangerous either open the
chassis or put your hand inside the chassis. If the device
is not working properly, unplug the device at once and
contact your retailer or the nearest distributor.
FEATURES
* Built-in 12V 1.2A Rechargeable Battery
* Built-in One Channel VHF Wireless Receiver
* With One Handheld MIC
* With One 6.35mm Wired MIC input Jack and 6.35mm CD
input Jack
* Separate Wired MIC, Wireless MIC and CD input Volume
Controls
* With 6.35mm REC out Jack
* With Treble, Bass and Echo Controls
* Power, RF and Charge LED Indicators
* Power ON/OFF Switch
* Power Supply: AC 120V/60HZ, DC12~15V or battery
Powered(8 "D" batteries)
* Power output: 100W
* Frequency Range: 160~270MHz
* Operating Range: Up to 100ft.
-1- -2-
Front