Precor EFX534i t - Manual (Page 17)

page 17
C O M M E R C I A L P R O D U C T S D I V I S I O N
16. Attach the left and right handlebars. Diagram 12. Perform the following
steps on one side of the unit and then, repeat the steps on the opposite side.
a. Remove the three bolts (E) and washers (F) from the Hardware kit. Place
the washers on the bolts.
b. Attach one handlebar at a time. Note that the handlebars’ mounting holes
are smooth on one side and slightly protrude on the other side. Place the
protrusions against the handlebar brackets.
c. Align the holes and insert the three bolts (E) and washers (F). Thread the
bolts (E) into the holes using your fingers.
d. Tighten the bolts securely using a ½-inch socket wrench.
e. Repeat steps a. through d. to secure the opposite handlebar.
17. Remove the fasteners from the hardware kit and cut the tie wraps that
secure the link arms.
a. Remove two screws (K), six washers (L), two steel bushings (A), and two
locknuts (M) from the hardware kit.
b. Place a washer (L) on each screw.
Diagram 12 Secure the
handlebars.
Protrusions
Handlebar
bracket
Tighten bolts securely.