Precor Cycles Integrated LCD Screen Option none - Manual (Page 7)

Cardio Theater Integrated Bracket Assembly Instructions
page 7
Preparing the Units
1 2
1. Remove the two plastic plugs located along the
upright support.
2. Feed the coaxial/power cable through the
upright support.
Locate the coaxial/power cable provided with
the LCD Screen. Feed the end of the coaxial/
power cable with two connectors (coaxial and
power) into the upper hole on the upright
support. Slide the cable and its two connectors
down until you can the connectors through the
lower hole.
3. Pull the cable and its two connectors out of the
lower hole.
Note: Leave about 3 feet (1 meter) of cable
hanging out of the upper hole. The coaxial/power
cable has three connectors at this end and will
be fed through the bracket assembly before it is
attached to the back of the display console.
Plastic plug
Plastic plug
Upright
support
Note: The recumbent cycle is
shown above. Find the plastic
plugs on the upright cycle in
similar locations.
3
Lower hole
Upper Hole
Upright
support