Panasonic P2HD AG-HPG20 - Manual (Page 7)

75
Menu
The underlined settings are the factory mode settings.
PLAYBACK FUNCTIONS screen
Item Description of settings
REPEAT PLAY This is used to set repeat playback.(Page 43)
ON:
Playback is repeated.
OFF: Playback is not repeated.
AUDIO OUT This is used to set the audio signals to be output from the AUDIO OUT connectors
(pin jacks) during playback.
CH1 · CH2:
CH1 connector = CH1 signal, CH2 connector = CH2 signal,
CH1:
CH1 connector = CH1 signal, CH2 connector = CH1 signal,
CH2:
CH1 connector = CH2 signal, CH2 connector = CH2 signal,
CH3 · CH4:
CH1 connector = CH3 signal, CH2 connector = CH4 signal,
CH3:
CH1 connector = CH3 signal, CH2 connector = CH3 signal,
CH4:
CH1 connector = CH4 signal, CH2 connector = CH4 signal,
AV OUT SETUP screen
Item Description of settings
CMPNT/SDI SEL This is used to set the format when D connector signals and HD/SD-SDI signals are
output.
(60 Hz regions)
AUTO:
Operation reflects the setting selected for the SYS FORMAT item on the
RECORDING SETUP screen.
1080i, 480i
(50 Hz regions)
AUTO:
Operation reflects the setting selected for the SYS FORMAT item on the
RECORDING SETUP screen.
1080i, 576i
SDI OUT This is used to set the SDI output.
ON:
SDI signals are output.
OFF: SDI signals are not output.
SDI METADATA This is used to set whether to superimpose the meta-data when HD-SDI signals are
output.
ON:
The meta-data is superimposed.
OFF: The meta-data is not superimposed.
SDI EDH This is used to set whether to superimpose error detection handling (EDH) when SD-
SDI signals are output.
ON:
EDH is superimposed.
OFF: EDH is not superimposed.
SETUP
(60 Hz regions only) The setup level of the video signals during playback is set.
0%:
0% is set as the output setup level.
7.5%A:
7.5%A is set as the output setup level.