Porter-Cable H1000IS-W - Manual (Page 11)

16. To make installation easier, submerge handle grips into warm soapy water.
Remove handle grips from soapy water and slide onto handles.
17. Squeeze snap button (12), slide into handle, and
release snap button through second hole.
NOTE: V of snap button is inserted first. Repeat
step on other handle.
18. Depress snap button (12), slide into handle
bracket, and release through first slot in handle bracket as shown. Secure
handle to handle bracket with screw (6) and locknut.
19. On other handle depress snap button (12), slide into handle bracket, and
release through first slot in handle bracket as shown. Secure handle to
handle bracket with screw (6) and locknut.
20. Attach handle bracket assemblies to frame with screws and locknuts (7).
Tighten securely.
NOTE: Orientation of handle assemblies to frame will depend on how the
operator wishes to operate snap button (12). If snap button is assembled
to outside of the generator frame it will be operated by the fingers. If snap
button is assembled to inside of the generator frame it will be operated by
the thumbs. The figure shows the snap button assembled to inside of
generator frame.
Risk of moving parts. Keep fingers away from
all moving parts. Contact with moving parts
can result in serious injury. Keep children away from the
generator at all times. They may not be able to recognize the
hazards of this product.
21. The portability kit is now ready for use.
22. To lower handle, depress snap button and fold handles down.
23. Raise handles and allow snap button to snap into place.
11- ENG A01296
12
6
12 6
12
7
12