Step 4: view leds/adjust mounting – Proxim TSUNAMI MP.11 5012-SUR User Manual
Page 12
Page 12
Copyright © 2006 Proxim Wireless
step 4: View leds/adjust Mounting
LEDs are located in the cable compartment.
When the unit is powered on, the 5012-SUR performs startup diagnostics.
When startup is completed, the LEDs show the operational state of the 5012-
SUR.
The following table shows the status of the LEDs when the 5012-SUR is
operational.
Status
Power
Wireless.Link
Ethernet.Link
Starting up
Three red blinks
followed by a
temporary solid
amber
N/A
N/A
Radio scanning
Blinking green
N/A
N/A
WORP link is up
Solid green
N/A
N/A
No WORP link
Blinking amber/
green
N/A
N/A
System failure
Solid red
N/A
N/A
No traffic on
interface
N/A
Solid green
Solid green
Normal operation
/ passing traffic
Solid green
Blinking green
Blinking green
Bootloader mode
Permanent solid
amber
N/A
N/A
If a wireless link is not established with the BSU, adjust the direction of the unit
so that the integrated antenna is more precisely aimed toward the BSU. When
the Power LED is solid green, the link is correctly established.