Chapter 2 manipulator style, 1 connecting to your computer, Connecting to your computer – Pioneer MEP-7000 User Manual
Page 7
DJS Ver. 1.600
7
2
Chapter 2 Manipulator Style
The Manipulator style uses the MEP-7000’s Control unit but does not use the MEP-
7000’s Drive unit.
It is necessary to install the driver software before connecting a MEP-7000 to your
computer. Please do not connect the MEP-7000 to your computer until you have
finished installing the driver software.
For information on how to install the driver software, please refer to
“ABOUT THE
DRIVER PROGRAM”
in the Operating Instructions of your MEP-7000.
When 2 or more MEP-7000s are connected
If you connect two or more MEP-7000s to your computer, only the first MEP-7000 will
be able to operate DJS.
2-1
Connecting to your computer
Connect the MEP-7000 to your computer with a USB cable and a USB auxiliary power cable.
For information on each of the cables that come with the MEP-7000 as well as each type of the
MEP-7000’s cable jacks, please refer to
“CONNECTIONS”
in the operating instructions of
your MEP-7000.
1
Connect the 5 V connector jack on the back of your MEP-7000’s
Control unit to the USB port on your computer with a USB auxiliary
power cable.
2
Connect the PC connector on the back of your MEP-7000’s control
unit to a USB port on your computer with a USB cable.
3
Start up your computer.
• It is also possible to start up your computer first and then make the connections to
your MEP-7000.
Warning!
Manipulator Style
For information on the Manipulator style, please
refer to
“USING DJ SOFTWARE”
in your MEP-
7000’s Operating Instructions.
Updating your Version of DJS
In order to use your MEP-7000 in conjunction
with DJS, it is necessary to update DJS to
version 1.600 or later. Please refer to the DJS
User’s Manual for directions on how to update
your version of DJS.
→
Warning!
Before Connecting to your
Computer
Disconnect the dedicated remote control cable
that is connecting the MEP-7000 Control unit
and the MEP-7000 Drive unit.
Control Unit Power Supply
The power for the control unit of the MEP-7000
is supplied from a USB port on your computer.
Connect the USB cable and USB auxiliary power
cable directly to your computer’s USB ports. Do
not connect them to a USB hub or any other kind
of USB splitter.
Starting up DJS
Start up DJS after making the connections to the
control unit of your MEP-7000. Also, take care
to close DJS before disconnecting the control
unit of your MEP-7000.