Profile MP6600 - Manual (Page 10)

9
ISO/DIN MOUNTING
If you own a Japanese vehicle, you can use the mounting screw holes on the side of the CD/MP3
player to attach to the factory mounting brackets.
! Detach the removable face of the MP6600 by depressing the release button
! Remove the outside trim ring by gently pulling at both outer edges (See page 10).
! Remove the side retaining plates by unscrewing the two phillips screws.
! Remove the brackets from the factory radio, paying close attention to their position.
! Attach the brackets to the MP6600 in the same position as the factory radio.
! After attaching the wiring harness to the factory wiring loom (See Electrical and
Signal Connections) and plugging the antenna lead , place the CD/MP3 player in the
dash aligning the mounting hole of the CD/MP3 player with the factory mounting
brackets. Secure the radio to the brackets using factory mounting screws.
FACTORY SIDE RETAINING PLATES,
STYLE AND SHAPE WILL VARY
FOR EACH VEHICLE
Once the CD/MP3 player is
secured, insert the face plate
with the right side of the face
plate angled in first then gently
push the left side of face plate
until it snaps completely in place.