Peavey KB2 User Manual

Page 6

R E

E A

A R

R P

P A

A N

N E

E LL

aiin

n LLiin

e O

utt ((9

9))

This low-noise‚ electronically-balanced XLR connector can be used to route signals to a mixing
console‚ recording device‚ etc.

d//R

ettu

urrn

n JJa

acck

kss M

aiin

nss ((110

0 &

& 1111))

This pair of 1/4" jacks allow the use of various auxiliary units (effects units‚ equalizers‚ etc.) in-line‚
before the power amp section.

e JJa

acck

k ((112

2))

This 1/4" jack accepts stereo headphones only.

4//M

niitto

orr IIn

utt JJa

acck

k ((113

3))

Use this 1/4" jack to connect to the output of any line-level device.

ell:: 3

3 LLo

w--IIm

ncce

e IIn

utt ((114

4))

For use with low-impedance microphones or other line-level sources equipped with a male XLR
connector.

ellss 3

3‚‚ 2

2 &

& 11 ((115

5))

These 1/4" jacks accept high-impedance microphones or line-level sources equipped with

⁄

" phone plugs.

Exxtte

errn

all S

err JJa

acck

k ((116

6)) ((K

3 o

nlly

y))

This 1/4" jack provides the powered signal from the amplifier. Use this jack to add a second speaker
cabinet in parallel. The external minimum speaker load impedance is 8 ohms.

IIE

C cco

ecctto

orr//d

etta

acch

blle

e lliin

e cco

orrd

d ((117

7))

This is a standard IEC power connector. An AC mains cord having the appropriate AC plug and ratings
for the intended operating voltage is included in the carton. The mains cord should be connected to
the amplifier before connecting to a suitable AC outlet.

U..S

S.. D

essttiicc A

C M

aiin

nss C

orrd

The mains cord supplied with the unit is heavy-duty‚ 3-conductor type with a conventional 120 VAC
plug with ground pin. Never break off the ground pin on any equipment. It is provided for your safety.
If the outlet used does not have a ground pin‚ a suitable grounding adapter should be used and the
third wire should be properly grounded.

This manual is related to the following products: