Pioneer RS-D7R - Manual (Page 55)

Connecting the Units
55
ENG/MASTER 96
55
Setting example
RCA Input Amplifier
RS-P90
RS-D7R—
(sold separately)
Front Woofer Subwoofer
Multi-CD player
(sold separately)
Front Mid-range Front Tweeter
Optical cable
IP-BUS cable
Routing the optical cable
Note:
• Try not to bend the optical cable sharply. If it is
necessary to bend it sharply, make sure that the
bending radius is at least 25 mm, otherwise the
cable will not transfer signals properly and so this
unit will not work properly.
• Route the optical cable so that nothing heavy rests
on it, and so that it cannot be stepped on or caught
in anything – for instance, a door.
• Make a loop of diameter at least 200 mm with the
remaining optical cable so that the cable does not
get strained.
• When plugging the optical cable into the unit, use
the supplied cable cramp to prevent the cables
from being bent sharply.
• Route the optical cable so that it does not get
caught in moving parts such as the gear shift, hand
brake, or seat sliding mechanism. Keep the cable
away from hot spots, such as near the heater out-
let.
7 Using the corrugated tube
To prevent the optical cable from being
strained, use the corrugated tube after cut-
ting it to the correct length.
• Insert the optical cable into the cor-
rugated tube.
Corrugated tube
Optical cable