Philips MCM196D - Manual (Page 14)

14
English
Basic Functions
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Plug and Play (for tuner installlation)
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "
AUTO
INSTALL - PRESS PLAY" is displayed.
2
Press ÉÅ on the system to start installation.
➜
"
PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "
TUNER" and "AUTO".
➜
PROG starts flashing.
➜
The system will automatically store the radio
stations with sufficient signal strength, starting
from FM, then followed by AM band.
➜
When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
To reinstall Plug and Play
1
In standby mode, press and hold ÉÅ on the
system until " AUTO INSTALL - PRESS PLAY"
is displayed.
2
Press ÉÅ again to start installation.
➜
All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
●
Press Çon the system.
➜
If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– If no stereo frequency is detected during Plug
and Play, "
CHECK ANTENNA" will be displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.
M I C R O S Y S T E M M C M 1 9 6 D
PG001-027 MCM196D_37_IFU_Eng 14/5/07, 13:20 14