Polk Audio DSW PRO 400 - Manual (Page 5)

Downward Firing Dimensions
DSW PRO 400: 13 3/4" W x 13 3/4" D x 14 5/8" H
(34.9cm W x 34.9cm D x 37.2cm H)
DSW PRO 500: 15 1/2" W x 15 1/2" D x 16 1/8" H
(39.4cm W x 39.4cm D x 41.0cm H)
DSW PRO 600: 16 1/2" W x 16 1/2" D x 17 1/8" H
(41.9cm W x 41.9cm D x 43.5cm H)
Forward Firing Dimensions
(height with rubber foot inserts)
DSW PRO 400: 13 3/4" W x 13" D x 15 7/8" H
(34.9cm W x 33.0cm D x 40.3cm H
DSW PRO 500: 15 1/2" W x 14 1/2" D x 17 5/8" H
(39.4cm W x 36.8cm D x 44.8cm H
DSW PRO 600: 16 1/2" W x 15 1/2" D x 18 5/8" H
(41.9cm W x 39.4cm D x 47.3cm H
Note: Optional grille adds to depth (sold seperately).
AC POWER CONNECTION AND AUTO ON/OFF
Dual Voltage Switch
DSW
PRO Series subwoofers are equipped with either a dual
voltage switch or an auto sensor.
DSW PRO 400 Auto Sense
DSW PRO 500 Selectable
DSW PRO 600 Selectable
WARNING: The correct voltage for your country has been set
at the factory. Only use the voltage setting specified for your
country. Using an improper setting may damage your subwoofer.
Main Power Switch
Turn power on/off via the AC MAIN switch.
Standby/Auto/On Switch
Your DSW
PRO Series subwoofer uses a 3-position power switch, which selects
your subwoofer’s operational mode. The three modes are: Standby, Auto and On.
Standby
With the switch in this position, the subwoofer will only turn on (become active)
when the user presses the power button on the remote control. Once active the
subwoofer will remain on regardless of whether an audio signal is present.
Auto
In the “Auto” position, your subwoofer automatically turns on when it senses
an audio signal and the LED located on the back of the subwoofer will be green.
We recommend the “Auto” mode if your subwoofer is always receiving
power (i.e., if it's plugged into a wall outlet). When no signal is present, the sub-
woofer will enter a “waiting” state after 15 minutes and the LED will turn yellow.
On
The subwoofer is always on and fully active in this mode. The LED on the back
of the subwoofer will be green. This mode is best if the subwoofer is plugged
into a switched power outlet. The remote control cannot be used to turn off
the subwoofer.
Note: You may want to leave your subwoofer unplugged or the AC MAIN
switch turned off during extended periods of non use, such as during a vacation.
Power Mode LED Colors and Their Meaning:
Green: Fully active
Yellow: Standby
Red: Protection
H
W D
Customer Service Hours of Operation: Monday-Friday, 9 AM -6 PM EST [email protected]
5
H
W D