Philips Clon99-BKI - Manual (Page 7)

-
VOL CH
1 2 3
4 5 6
7 8 9
0
SELECT
M
SLEEP
A/CH
MUTE
POWER
+
CC
RECALL
RESET
CH GDE
GUEST SETUP SETUP
TV TV DCM
A B C D
E F G
SMART
PLUG
75 Ω
ANT/
CABLE
EXTERNAL
SPEAKER
1
2
6
PHILIPS
SMARTLOADER 99
Copyright PCEC 1999
System Version D.0
PN 3135 019 01681
PRESS POWER TO BEGIN
Philips SmartLoader 99
System Version D.0
1 - Read TV
2 - Write TV With Settings
3 - Write TV Without Settings
4 - Erase SmartLoader Memory
5 - System Test
6 - Exit SmartLoader
Stored Memory Type 01, 04
Philips SmartLoader 99
System Version D.0
1 - Read TV
2 - Write TV With Settings
3 - Write TV Without Settings
4 - Erase SmartLoader Memory
5 - System Test
6 - Exit SmartLoader
Write? Press 0 to confirm
Philips SmartLoader 99
System Version D.0
1 - Read TV
2 - Write TV With Settings
3 - Write TV Without Settings
4 - Erase SmartLoader Memory
5 - System Test
6 - Exit SmartLoader
Writing Block 23 of 63
Philips SmartLoader 99
System Version D.0
1 - Read TV
2 - Write TV With Settings
3 - Write TV Without Settings
4 - Erase SmartLoader Memory
5 - System Test
6 - Exit SmartLoader
Finished Writing Memory
3
8 4
5
7
7
P
ROGRAMMING A
T
ELEVISION
’
S
I
NTERNAL
M
EMORY
W
RITING
TV M
EMORY
After the Memory has been read from
one television, the Clon99-BK
SmartLoader is now ready to write the
memory to other televisions. This mem-
ory can be written with or without cer-
tain settings. These settings include:
Picture Adjustment, Minimum and
Maximum Volume, and the On Volume
settings.
Plug one end of the cable into the
jack provided on the SmartLoader. Then
plug the other end into the jack provided
on the back of the TV. The TV jack is
next to the Antenna Input terminal.
Push the Slide Switch to the ON
position on the SmartLoader. If the TV
is currently off, it should turn on within
15 seconds.
Within 20 seconds, the SmartLoader
on-screen display should appear on the
TV screen. If the display does not
appear, check connections and push the
Slide Switch to the ON position again.
If there is still no response from the
SmartLoader, replace its 9-volt battery.
Press the POWER button on the
remote to display the Clon99-BK
SmartLoader Setup Menu.
With the Setup Menu visible, press
the Number 2 button on the Remote
Control to select the 2nd option “Write
TV With Settings” or press the Number
3 button to select the third option
“Write TV Without Settings.”
The screen will ask “Write?” Press
the 0 button on the remote to confirm
and begin the procedure.
The screen will indicate “Writing
Block 24 of 63” while the Clon99-BK
SmartLoader is downloading the data.
The display will then read
“Finished Writing Memory” when the
procedure has been completed.
BEGIN
Typical rear jack
panel of ITV
Clon99-BK SmartLoader Box
ON/OFF Slide Switch
LED