Pella Clad Hinged Patio Door 801V0101 - Manual (Page 7)

A. Install the hardware. Refer to the instructions included in
the hardware box.
B. Insert backer rod into the space around the door 3/8" to
1/2". This should provide at least a 3/8" clearance between
the backer rod and the exterior face of the door.
Note: Backer rod adds shape and depth for the
sealant line.
C. Apply a bead of high quality exterior grade sealant
to the entire perimeter of the door. At each end of the
bottom of the door, insert sealant into the spaces between
the bottom of the door and the sill support and
connect it to the perimeter sealant.
D. Shape, tool and clean excess sealant. When finished,
the sealant should be the shape of an hourglass.
Note: This method creates a more flexible sealant
line capable of expanding and contracting.
E. Remove plastic guards at the base of the door once
construction is complete.
INTERIOR FINISHING
If products cannot be finished immediately, cover with clear plastic to protect from dirt, damage
and moisture. Remove any construction residue before finishing. Sand all wood surfaces lightly
with 180 grit or finer sandpaper. DO NOT use steel wool. BE CAREFUL NOT TO SCRATCH
THE GLASS. Remove sanding dust.
Pella products must be finished per the below instructions; failure to follow these instructions
voids the Limited Warranty.
• On casement and awnings, it is optional to paint, stain or finish the vertical and horizontal
sash edges.
• On single-hung and double-hung, do not paint, stain or finish the vertical sash edges, any
finish on the vertical sash edges may cause the sash to stick; it is optional to paint, stain or
finish the horizontal sash edges.
• On patio doors, it is optional to paint, stain or finish the vertical and horizontal panel edges.
Note: To maintain proper product performance do not paint, finish or remove the weather-
stripping, mohair dust pads, gaskets or vinyl parts. Air and water leakage will result if these
parts are removed. After finishing, allow venting.
Pella Corporation is not responsible for interior paint and stain finish imperfections for any
product that is not factory-applied by Pella Corporation. Use of inappropriate finishes, solvents,
brickwash, or cleaning chemicals will cause adverse reactions with window and door materials
and voids the Limited Warranty.
For additional information on finishing see the Pella Owner’s Manual or go to www.pella.com.
5B
5C