Philips DVD707/781 - Manual (Page 12)

13
English
General operation
Connecting the power supply
1 Plug the female end of the power cable supplied into the Power
connector on the rear of the player.
2 Plug the male end of the cord into an AC outlet.
Turning on the power
¶ Make sure that audio and video output has been connected to TV.
¶ Choose the available AV mode and connect your TV set to our DVD
player.
¶ Press power on/off button on the front panel to turn on the player.
Loading discs
¶ Press the OPEN/CLOSE button on the front player to open the disc
tray.
¶ Load your chosen disc in the tray, label side up (also when a double
sided DVD is inserted). Make sure the disc is placed properly in the
correct recess.
¶ Gently push the tray, or press OPEN/CLOSE button to close the tray.
Playback will start automatically.
NOTE:
– If your TV system is not align with your DVD player, the player might not
work. If this happens, you can press the OPEN/CLOSE key to open the
disc tray and press the ZOOM key on the remote control to enforce the
player to adapt to your TV system.
Options between component video and S-
Video
¶ Ensure that the DVD player and television has been connected by an
alternative cable.
¶ In OPEN mode, press the SLOW BACKWARD key to choose an
alternative setting depending on the video connection between the
DVD player and television (refer to chapter [Video Connection] at page
11 for details) and the word “ CVBS+ SVIDEO” or “ YCbCr” appears on
the TV screen.
¶ The DVD player will execute to the corresponding setup automatically.
NOTE:
– If there is some image distortion, check if the video connection is
corresponding with the operation on your remote control. If not, press the
SLOW BACKWARD key again and repeat the above steps.
Remote control battery installation
¶ Open the battery compartment cover.
¶ Insert two batteries inside the battery compartment.
¶ Close the cover.
CAUTION:
– Don’t mix old and new batteries. Never mix different types
of batteries (standard, alkaline, etc.)
Remote control operation
¶ Unless mentioned, all operations can be carried out with the remote
control. Always point the remote control directly at the player, making
sure there are no obstructions in the path of the infrared beam.
¶ When there are corresponding keys in the front panel, they can also be
used.