Pioneer VSX-1015-K - Manual (Page 14)

Connecting up 03
14
En
Chapter 3:
Connecting up
Important
• Before making or changing any connections, switch
off the power and disconnect the power cord from the
AC outlet.
About cable types
Analog audio cables
Use stereo RCA phono cables to connect analog audio
components. These cables are typically red and white,
and you should connect the red plugs to R (right)
terminals and white plugs to L (left) terminals.
Digital audio cables
Commercially available coaxial digital audio cables or
optical cables should be used to connect digital
components to this receiver.
• When connecting optical cables, be careful when
inserting the plug not to damage the shutter
protecting the optical socket.
• When storing optical cable, coil loosely. The cable
may be damaged if bent around sharp corners.
• You can also use a standard RCA video cable for
coaxial digital connections.
Video cables
Standard RCA video cables
These cables are the most common type of video
connection and should be used to connect to the
composite video terminals. They have yellow plugs to
distinguish them from cables for audio.
S-video cables
S-video cables give you clearer picture reproduction than
standard RCA video cables by sending separate signals
for the luminance and color.
Component video cables
Use component video cables to get the best possible
color reproduction of your video source. The color signal
of the TV is divided into the luminance (
Y ) signal and the
color ( P B and P R ) signals and then output. In this way,
interference between the signals is avoided.
Right (red)
Analog audio cables
Left (white)
Coaxial digital audio cable Optical cable
Standard RCA video cable
S Video
Green (Y)
Blue (P B )
Red (P R )
Component video cables
VSX_1015.book.fm 14 ページ ２００５年３月７日 月曜日 午後７時０分