Peavey Supreme - Manual (Page 4)

EFFECTS SEND (8)
Output for supplying signals to external low-level effects or signal processing equipment.
REVERB LEVEL (9)
Controls the overall reverb level.
POST GAIN
Controls the overall volume level of the Lead channel. The final level adjustment should be made after the
desired sound has been achieved.
LOW, MID, HIGH
Passive tone controls that regulate the low, mid, and high frequencies for the Lead and Clean channels,
respectively.
GAIN SWITCH (12)
Boosts the overall system gain. Depress to the “in” position to activate.
THRASH SWITCH (13)
Notches the mid range about 20
PRE GAIN (14)
Controls the input volume level of the Lead channel.
CHANNEL SELECT SWITCH (16)
Allows selection of the Lead or Clean channel. The “in” position of the switch selects the Lead channel and
the “out” position selects Clean.
NOTE: Channel selection may also be achieved by the remote footswitch. If remote selection is desired, the
channel switch must be in the “in” (Lead) position.
BRIGHT SWITCH (17)
Provides a preset boost (6
to treble frequencies. To activate, depress the switch to its “in” position.
VOLUME (18)
Controls the volume level of the Clean channel.
LOW GAIN INPUT (19)
Provided for instruments that have extremely high outputs, which can result in overdriving (distorting) the
High Gain input. If both inputs are used simultaneously, the output levels are the same (both are low gain).
HIGH GAIN INPUT (20)
Used for most electric guitars. It is 6
louder than the Low Gain input.