Philips VRZ360 - Manual (Page 50)

50 Glossary
AUDIO IN/OUT Jacks: jacks located on the front and back of the VCR which are
used to record audio from another source (IN) or to send audio to another source
(OUT).
Automatic Channel Programming: process in which the VCR scans all available
channels and places the ones you receive in its memory. Then, when you press the
CH(annel) 8/9 buttons, you only scan through channels you receive.
Bands: settings that allow you to tune channels.
• Antenna – VHF (very high frequency; channels 2 - 13) and UHF (ultra high frequen-
cy; channels 14 - 69).
• Cable – standard channels can be received without a Cable Box.
Cable Box/DBS Output Channel: channel 03 or 04.
DBS: Direct Broadcast System.
Dubbing: copying a tape using a second VCR.
Frame: a single still picture.
HQ: high quality; a feature in the VCR circuitry which provides enhanced picture
detail.
OTR: one-touch recording; programming a timer recording that starts immediately
and records for 30 minutes to six hours, whichever you specify.
Remote Control: the small electronic unit that came with your VCR; allows you to
operate your VCR from a distance. The remote control may also operate some fea-
tures of your TV, Cable Box, or DBS.
RF coaxial cable: the cable supplied with your VCR. Use it to connect your VCR to
your TV (or Cable Box/DBS, if applicable). The supplied cable is a snap-on type.
However, you may also use a screw-on type if you prefer.
Special Effects: forward and reverse searching; viewing a still picture; or viewing a
slow motion picture.
Tape Speeds: how fast the tape travels during a recording or playback.
• LP (long play) – average tape speed (playback time for a T120 tape is approxi-
mately four hours); available for playback only. Although the VCR will play tapes
recorded in LP, LP will not appear on the display panel or in the on-screen status
display.
• SLP (super long play) – slowest tape speed (recording/playback time for a T120
tape is approximately six hours).
• SP (standard play) – fastest tape speed (recording/playback time for a T120 tape
is approximately two hours); best picture quality.
VCR: video cassette recorder.
VIDEO IN/OUT Jacks: jacks located on the front and back of the VCR which are
used to record video from another source (IN) or to send video to another source
(OUT).
VRZ360 4/7/99 9:54 PM Page 50