Philips SWW1800/27 - Manual (Page 4)

3
2
DC 5V DC 5V
Enjoy
Install
1
Open the battery compartment.
2
Insert two AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
1
Go to the source menu under the settings menu of your HDTV.
2
Select the HDMI input to which the receiver is connected.
Install remote control batteries
Turn on the power of your
HDTV
Note
You cannot control the receiver with the supplied remote control and the •
receiver follows the transmitter’s status to enter/exit the standby mode.
The synchronization of standby between the HDTV and the receiver
•
depends on the capability of the HDTV.