PYLE Audio PLE702B - Manual (Page 7)

PLE702
B
7-Band Equalizer/Amplifier
with Subwoofer Crossover and Bass Boost
LED level display
power indicator LED
fader control
volume control
equalizer controls
subwoofer frequency control
subwoofer boost control
power connections
subwoofer channel outputs
line channel inputs
speaker connections
these rows of LEDs display the Amplifier Output Levels. Left and right channels are
displayed independently at peak levels.
this LED is illuminated when the unit is properly powered, grounded and the remote
power has been turned on.
• in a 4 Speaker system, rotating the knob to the FRONT side increases the level
of the front speakers; rotating to the REAR side increase level of the rear speakers.
At mid position, both sets of speakers are at maximum level.
• in a 2 Speaker system, the fader control should be rotated to the position which
provides highest levels for both sets of speakers.
allows adjustment of sound level for particular program material or source.
this seven-band equalizer gives you control over the output levels at various
frequencies.
lets you adjust the subwoofer frequency and crossover point from 40-400 Hz.
lets you adjust the subwoofer boost level from a 0 to +18 dB increase.
connect to power source as follows:
+12V: Connect a red wire of at least 12 gauge to the car battery or other power
source.
GROUND: Connect a black wire of at least 12 gauge to car chassis for
ground connection
REMOTE: Connect an orange wire to remote activating (12V DC) wire of car stereo
or other head unit.
RCA cables are used to connect the sub outputs to the subwoofer amplifier inputs.
RCA cables are used to connect the front input signal from head unit or other source.
the connections are used to power a front and rear speaker systems
5
features and specifications
center frequencies 65 Hz · 150 Hz
400 Hz · 1.4 KHz
2.4 KHz · 6 KHz
15 KHz
frequency response 20 - 20 KHz (+/– 1 dB)
input level
(for 10% THD output)
200 mV
total harmonic distortion (THD)
(at 15W output)
< 0.5%
speaker impedance 4-8 Ohms
signal-to-noise ratio (S/N) 90 dB
separation 60 dB
current drain 6A maximum
power supply voltage 10-16V DC Neg. Ground
160 x 29 x 140
6.3 x 1.1 x 5.5
dimensions (W x H x L)
mm
inches
subwoofer crossover 40 - 400 Hz
bass boost 0 - +18 dB
amplifier power 30 Watts (RMS) x 4