Philips Avent SCD525 - Manual (Page 12)

4 Insert the small appliance plug into the charger, put the adapter in a power outlet and place
the parent unit in the charger (Fig. 11).
, The charging light on the charger goes on.
, The display shows a charging battery symbol to indicate that the parent unit is charging.
5 Leave the parent unit in the charger until the battery pack is fully charged.
, During charging, the charging light on the charger stays on.
, When the battery pack is fully charged, the display of the parent unit shows a full battery
symbol T.
- When you charge the parent unit for the first time or after a long period of non-use, switch it
off and let it charge continuously for at least 10 hours.
- Charging normally takes 8 hours, but it takes longer when the parent unit is switched on while
charging. To keep the charging time as short as possible, switch off the parent unit during
charging.
- When the battery pack is fully charged, the parent unit can be used cordlessly for up to 24
hours.
Note: When the parent unit is charged for the first time, the operating time is less than 24 hours. The
battery pack only reaches its full capacity after you have charged and discharged it four times.
Note: When the parent unit is not in the charger, the battery pack gradually discharges, even when the
parent unit is switched off.
Using the appliance
Use the baby monitor for its intended household use as described in this manual.
1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 12).
Make sure the baby unit is at least 3.5 feet/1 meter away from the parent unit.
2 Press and hold the on/off button 3 on the baby unit until the green power-on light goes
on. (Fig. 13)
Note: The power-on light always lights up green, even when there is no connection with the parent unit.
, The nightlight lights up briefly and then goes out again.
, The battery light T lights up briefly and then goes out again. (Fig. 14)
3 Press and hold the on/off button 3 on the parent unit until the sound level lights light up
briefly. (Fig. 15)
, The display goes on and the battery symbol appears on the display (Fig. 16).
, The LINK light flashes red and the message ‘Searching’ appears on the display. (Fig. 17)
, The LINK light on the parent unit turns green and lights up continuously when a connection
has been established between the baby unit and parent unit. The message ‘Linked’ appears on
the display. (Fig. 18)
, After 2 seconds the message ‘Linked’ disappears and the temperature value is shown on the
display. (Fig. 19)
, If no connection is established, the LINK light on the parent unit flashes red. The parent unit
beeps from time to time and the message ‘Searching’ appears on the display, followed by the
message ‘Not Linked’ (Fig. 20).
positioning the baby monitor
1 Place the baby unit at least 3.5 feet/1 meter away from your baby (Fig. 21).
2 Place the parent unit within the operating range of the baby unit. Make sure it is at least
3.5 feet/1 meter away from the baby unit to avoid acoustic feedback (Fig. 22).
For more information on the operating range, see section ‘Operating range’ below.
EngliSh 12