Polycom Real-Time Media Conferencing Platform RMX 2000 - Manual (Page 42)

Chapter 1- Hardware Description
1-36
Replacing the RTM IP Card
The RTM IP card on the rear of the RMX 2000 provides connectivity to all
the MCU modules. Use the following procedure to replace the RTM IP
card:
1
Ensure that the power switch on the RMX 2000 is turned OFF (O).
2 Unscrew the captive screws on the rear panel of the RMX 2000 that
secure the RTM IP card.
3 Use the metal ejector levers to pull the RTM IP card out of its slot in
the backplane.
4 Carefully slide the RTM IP card out through the rear panel.
5 On the card to be installed, move the ejector levers to their fully open
position.
6 Slide in the replacement RTM IP card.
7 Push the RTM IP card firmly into the backplane, making sure it is
properly seated in its slots.
8 Ensure that the metal ejector levers are fully retracted into their
housings.
9 Tighten the captive screws on the rear panel of the RMX 2000 that
secure the RTM IP card.
10 Turn ON the RMX 2000.
For more information on the Card Configuration Modes after reset, see "MPM
and MPM+ Configuration Modes” on page
1-20 .