Philips 35LC - Manual (Page 5)

IMPORTANT: The Removable
Guide Comb Attachment must
be in place on the Hair Clipper
in order to use the One Step
Select Switch.
The One Step Select Switch
allows you to adjust to seven
different hair lengths, so that
you may achieve the exact
length and look you want.
1. To adjust settings, push One
Step Select Switch to desired
setting.
2.Hair Length Selector will
“click” and automatically lock
into place at each setting
(Fig. 1).
■ Start at higher setting
(#6 or #7), to prevent
trimming off too much hair.
■ As you become familiar with
the settings, adjust One Step
Select Switch to desired trim-
ming length (Fig. 2).
1. VOLTAGE
This Hair Clipper operates only
on 110-120V AC. In North
America, Central America, and
South America, the most com-
mon voltage is between 110V
and 130V AC. If operating this
Hair Clipper on a higher for-
eign currency, a 50-Watt con-
verter should be used. An
adaptor plug may also be nec-
essary for cord usage in for-
eign countries. When travel-
ing overseas, it is suggested
that you take all adaptor plugs
with you to ensure compatibil-
ity to most foreign outlet con-
figurations.
Norelco Travel Adaptor Plugs
(Model TP5), 50-Watt
Converter (Model TC50) or
Adaptor/50-Watt Converter Kit
(Model TK3) may be pur-
chased at a store near you or
at a Norelco Service Store
Location.
■ Use only the cord provided.
2. TRIMMING
1. Connect cord provided to
Hair Clipper.
2. Plug into 120V AC outlet.
3. Slide ON/OFF switch ON.
■ Begin trimming.
4. When finished, turn Hair
Clipper OFF and unplug.
The Guide Comb may be
removed if you are:
■ defining/outlining hair line
edges
■ trimming nape of neck
■ trimming with a comb or
fingers
A.TO REMOVE
GUIDE COMB
1. Be certain Hair Clipper is in
OFF position.
2. While holding Hair Clipper
base with one hand, grasp
sides of Guide Comb and
gently lift Guide Comb away
from Hair Clipper (Fig. 3).
NOTE: One Step Select Switch
may be on any setting when
removing Guide Comb and
when trimming without Guide
Comb.
B.TO REPLACE
GUIDE COMB
1. Be certain Hair Clipper is in
OFF position.
2. Hold Hair Clipper in one hand
and replace Guide Comb until
it “clicks” into position.
NOTE: The Guide Comb can be
placed on the Hair Clipper
only one way. If it does not fit
properly at first, reverse it.
7
3. ONE STEP SELECT 7-POSITION HAIR
LENGTH SELECTOR AND REMOVABLE
GUIDE COMB ATTACHMENT
SETTINGS
7 leaves hair approximately 17 mm in length
6 leaves hair approximately 15 mm in length
5 leaves hair approximately 13 mm in length
4 leaves hair approximately 11 mm in length
3 leaves hair approximately 9 mm
in length
2 leaves hair approximately 7 mm in length
1 leaves hair approximately 4 mm in length
4. GUIDE COMB ATTACHMENT
2
3
1