PYLE Audio PT590AU - Manual (Page 5)

1 2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
23
22
Using the Remote Control
1.Power on/off control selector
2.HDMI audio switch selector
3.Tuner band control selector
4.Tuner memory selector
5.Channel source output selector
6.Treble volume increase selector
7.Left balance selector
8.Treble volume decrease selector
9.USB/SD play selector
10.USB/SD-skip selector
11.Side left volume adjustment selector
12.Center volume adjustment selector
13.Tuner number selector
14.Input mode selector
15.DSP control selector(live, hall, church)
16.Bass volume increase selector
17."Mute mode" control selector
18.Master volume control selector
19.Right balance selector
20.Bass volume decrease selector
21.USB/SD pause selector
22.Side right volume adjustment selector
23.Subwoofer volume adjustment selector
Battery Installation
1.On the back of the remote control, push the tab and lift off the battery cover.
2.Obtain two (2) fully-charged AAA batteries. Match the + and - marks on the batteries to the + and -
marks in the battery case, then insert the new batteries.
3.Align the cover keys with the case holes and press the cover back into place. The tab should click when the
cover is locked.
4.Test the unit by pressing POWER or any mode key. If the batteries are inserted correctly, the selected mode key
will blink once.
" " " " " " " "
Note
Do not leave the remote control in an extremely hot or humid place.
Do not use a new battery with old ones.
Do not mix manganese batteries with other kinds of batteries.
Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.
If you do not intend to use the remote control for an extended period of time, remove the batteries to avoid
possible damage from battery leakage and corrosion.
.3.