Philips DVD712 - Manual (Page 13)

Hookups (cont’d) 13
Connecting to a TV and a Stereo Receiver
Stereo has Dolby Surround or
Stereo has 2-channel analog (right and left Audio In jacks)
COAXIAL
DIGITAL AUDIO OUT
PCM-MPEG2-Dolby Digital-DTS
L R (CVBS)
VIDEO OUT AUDIO OUT S-VIDEO OUT
(Y/C)
SUB WF OUT OPT OUT
1
2
1
2
Y P B /C B P R /C R
VIDEO OUT
L L
AUDIO (LEFT) IN
AUDIO (RIGHT) IN
Stereo
(example only)
Back of TV
(example only)
S-Video In
S-Video In
1
1
Connect an S-Video cable to the S-VIDEO OUT jack of the DVD
Player and to the corresponding S-VIDEO IN jack on your TV. Use
an S-Video cable (not supplied).
Or, use the CVBS VIDEO OUT jack (using the supplied yellow video cable)
or Component VIDEO OUT jacks. Details are on pages 10 and 12. You only
need one video connection.
2
Connect the supplied red and white audio cables to one set of the
Left and Right AUDIO OUT jacks on the DVD Player. Connect
the other end of the cables to the left/right AUDIO IN jacks on
the Stereo Receiver. Match the cable colors to the jack colors.
3
Connect the power cords of the DVD Player, Stereo Receiver,
and TV to the power outlet. Turn on the power of the TV, Stereo
Receiver, and DVD Player.
4
Set the TV to the correct Video In channel. Such channels may be
called AUX or AUXILIARY IN, AUDIO/VIDEO or A/V IN, S-Video In,
EXT1 or EXT2, etc. These channels often are near channel 00. See your
TV owner’s manual for details. Or, continue to change channels at the
TV until you see the DVD Player’s screen saver on the TV screen.
5
Set your Stereo Receiver to the correct Audio In channel or
sound source. Refer to the owner’s manual of the Stereo Receiver.
2