Panasonic AJ-HPX3700 - Manual (Page 34)

193 Menu: Menu Description Tables
Me
nu
MIC/AUDIO2
Items/
Data Saved
Adjustable
Range
Remarks
FRONT MIC
POWER ON
OFF Select the phantom power supply for the
front microphone.
– C U F –
REAR MIC
POWER ON
OFF Select the phantom power supply for the
rear microphone.
When “OFF” is selected, no phantom
power is supplied even if the LINE/MIC/
+48V selector switch is set to [+48V].
– C U F –
MONITOR
SELECT STEREO
MIX When the MONITOR select switch is set
to [ST] (stereo), select the signal format
for the monitor output.
– C U F –
FRONT MIC
LEVEL –40dB
–50dB Select the front microphone input level.
– C U F –
REAR MIC CH1
LVL –50dB
–60dB Select the rear microphone input level.
– C U F –
REAR MIC CH2
LVL –50dB
–60dB Select the rear microphone input level.
– C U F –
REAR LINE IN
LVL –3dB
0dB
+4dB Select the rear line input level.
– C U F –
AUDIO OUT LVL –3dB
0dB
+4dB
Select the audio output level.
– C U F –
HEADROOM 18dB
20dB Set the headroom (standard level).
– C U F –
WIRELESS
WARN ON
OFF Select whether or not to enable the
alarm to trigger for poor wireless receiver
reception.
– C U F –
WIRELESS
TYPE SINGLE
DUAL Select the type of wireless receiver.
SINGLE:
Select a single channel wireless
receiver.
DUAL: Select a 2-channel wireless
receiver.
– C U F –
TC/UB
Items/
Data Saved
Adjustable
Range
Remarks
TC MODE DF
NDF Set the time code mode.
DF:
Drop frame.
NDF: Non drop frame.
Note
When the unit operates at 50 Hz or in
24P or 24PA mode, the non-drop frame
is always used.
– C U F –
UB MODE USER
TIME
DATE
EXT
TCG
FRM RATE
REGEN Select the user bits mode.
USER: Select UB value set in the LCD
section.
TIME: Select local time (hours,
minutes, seconds).
DATE: Select local date and time (2 last
digits of year, month, date, time).
EXT: The user bits input to the TC IN
connector are recorded.
If reading fails, USER value is
retained.
TCG: TCG value enters UB.
FRM RATE:
Select the shooting information
(e.g. frame rate) for the camera.
For more information, see
[Frame rate information
recorded in user bits] (page 63).
When clips recorded in native
mode are played back, the frame
rate information recorded in
users bits in the VAUX area is
output.
REGEN: Read out value stored in the
card and record value
continuously.
Note
When the unit is in 720P mode, “FRM
RATE” is always selected.
– C U F –
AJ-HPX2700G-VQT1V27_eng.book 193 ページ ２００８年９月２日 火曜日 午後５時４３分