Channel/mic controls – Peavey PM 1 User Manual

Page 6

8. PHONO INPUT GROUND SCREW

Grounds from external turntable(s) should be connected at this point for a proper input connection.

9. MIC 1 INPUT

The Mic 1 Input is located on the top of your PM One. (See diagram on back.) The Mic 1 Input is a
balanced, low impedance controlled by the Microphone Fader (11). The Voice-over Switch (12) can
be placed in the TALK position while the Mic 1 Input is active to temporarily drop the music level by
12 dB.

10. MIC 2 INPUT
The Mic 2 Input is a balanced, low impedance TRS 1/4" input controlled by the Channel Fader (13)
of Channel 4. The Channel Input Select Switch for Channel 4 must be in the MIC 2 position for Mic
2 to be active. The Mic 2 input is located on the rear of the unit (see diagram on Page 4.)

FRONT PANEL

CHANNEL/MIC CONTROLS

This section describes the controls which affect the four individual channels and the Mic1/Mic 2
inputs. Refer to the diagram above for physical locations.

11. MICROPHONE FADER

This fader controls the level of the MIC 1 Input (9) only. The MIC 2 Input (10) is an optional
microphone input placed on Channel 4. Placing the fader in the Т0У position will produce minimum
gain or no signal. Moving the fader to the Т10У position will give maximum gain or the highest
output signal.

12. VOICE-OVER SWITCH

This switch is used to reduce Channels 1-4 by 12 dB. When placed in the OFF position, all
channels return to their normal level. Use this switch to punch into your program with vocal
material and punch back out to return to music.