POSIFLEX Business Machines PP5600 SERIES - Manual (Page 16)

2 - 4
bracket of the print mechanism as in the picture.
•
Close the top cover by fitting its rear end lug first for ribbon
replacement only or go on loadin g paper as in next paragraph.
C.
LOADING PAPER
1. Drop the paper roll inside the paper compartment in the
orientation as shown in left picture below.
2. Cut the leading edge of paper roll perpendicular to paper
direction and now please turn on the
power to the printer by pressing the
power button in front side of the
printer. Insert the leading end of the
paper roll into the paper intake slot on
print mechanism. Insert the paper till
you feel the front end caught by the
paper feed roller inside the print mechanism then the paper
will automatically advance to proper position (paper exit of
print mechanism). In case there was a slip at the insertion of
the leading end of paper roll and you want to keep same
heading clearance, you may press the FEED button to
advance the paper to position.
3. Close the top cover back. Should the front end of paper roll
tend to curl as when it comes near end of the paper roll, it is
advisable to press the FEED button to check if the paper
comes out of the slot in top cover. Engage manual support to
make sure it comes out if it fails.