POSIFLEX Business Machines PP5600 SERIES - Manual (Page 14)

2 - 2
When the printer is used as a kitchen printer, please use this
port for kitchen bell connection instead.
4. Power connection
The power connector is a 3 pin jack between the peripheral
connector and the parallel connector. Either a Posiflex supplied
power adaptor or a printer power cable from a Posiflex POS
system can be connected to this connector to supply power for
this printer. During insertion of the power plug, be sure to hear
the click to obtain a firm contact.
CAUTION: Before doing the insertion or extraction of the
power plug, be sure to pull the outer sleeve of the
plug backward to release the internal latch.
Failure to do this could damage the power plug.
Such damage is considered as an artificial
destruction and is not covered by the warranty.
When all the above cable connections are made correctly,
you may connect your power adaptor to the wall outlet. Make
sure that the type of power cord and the voltage requirement of
the power adaptor meet the local power conditions. Do not turn
the power on for the moment.
B. LOADING / REPLACING RIBBON
CASSETTE
•
Turn off the power to the printer.
•
Lift the front end of the top cover
to remove it.
•
Open the auto cutter by pulling the
tab up if it is installed in the printer.
(PP5600B)
•
Remove slack in the ribbon by
Lift
Tab