PYLE Audio PWMA820 - Manual (Page 3)

1. POWER SUPPLY
1) AC Power: Before operation, please confirm the voltage is same
as the specified one marked on the label.
2) Built-in Rechargeable Battery: You can use built-in rechargeable
battery without plug in AC power.
3) When the Low Voltage Indicator comes on yellow, it indicates the
battery voltage is low. Please plug in AC power to charge the
battery. When battery is fully charged, low voltage indicator will
extinguish.
4) If the unit is not going to be used for a long time, please charge
the battery every 2 months. Charging time is 8-10 hours for each
time.
2. OPERATION OF AMPLIFIER
1) Use provided AC cord to connect this unit to suitable power
socket. Pay attention to the voltage. Charge indicator will light.
Or use built in battery.
2) Turn on amplifier power switch, power indicator comes on red.
3) Adjust MASTER volume control to suitable level.
4) Turn on handheld microphone, RF indicator on receiver will
light. Wireless microphone volume can be adjusted by
W/MIC 1.
5) Adjust BASS, TREBLE and ECHO to the suitable level. Now you
are ready to talk.
6) Wired microphone(not included) can be connected to MIC 1 and
MIC 2 jack. MIC volume can be adjusted by W/MIC 1 and MIC 2
volume control respectively. You can use the wireless MIC and
the two wired MIC at the same time.
---3--- ---4---
OPERATION
7) To play guitar, connect guitar to GUITAR IN jack. Guitar volume
can be adjusted by Guitar Volume control.
8) External audio device can also be connected to AUDIO IN jack.
Audio volume can be adjusted by AUDIO volume control.
9) To play MP3 player, refer MP3 player instruction.
OPERATION
1) Insert attached 9V battery into wireless transmitter.
2) Insert headset MIC or clip-on MIC to body pack transmitter
MIC-IN jack. Adjust body pack transmitter volume switch to
suitable level.
3) Move Power Switch to ON position. Power indicator will flash
once then extinguish. RF indicator on amplifier will light to
indicate receiving signal. Now you are ready to talk.
4) To mute the sound, move power switch to middle.
5) To turn off the transmitter, move power switch to OFF position.
6) If Power indicator of wireless transmitter lights red, it indicates
the battery power is low. Please replace new battery.
3. OPERATION OF WIRELESS TRANSMITTER
1
2
3
4
1. MIC grill(capsule inside)
2. Power indicator
3. Power Switch
Headset MIC Lavalier MIC
4
3
2
5
6
4. Battery cover
5. Volume control
6. MIC-IN jack
(Optional) (Optional) (Optional)