Philips FW-C80 - Manual (Page 24)

3139 116 19662 (ENG)
24 TIMER SLEEP TIMER
Sleep (only on remote control)
This feature allows you to select a
length of time after which the system
will switch to the standby mode
automatically.
1 Press SLEEP on the remote control
repeatedly to select a period of time.
™ The selections are as follows (time
in minutes):
60 ™ 45 ™ 30 ™ 15 ™ OFF ™
60 …
™ "SLEEP XX" or "OFF" will be
displayed. " XX" is the time in
minutes.
2 When you reach the desired length
of time, stop pressing the SLEEP
button.
™ After this amount of time passes,
the system will switch to the
standby mode.
To switch off the Sleep Timer
• Press
SLEEP repeatedly until " OFF"
is displayed, or press the
STANDBY ON button.
5 Press CLOCK/TIMER again to
store the setting.
™ The clock starts.
• To exit without storing the setting,
press Ç on the system.
Notes:
– During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically.
– When a power interruption occurs, the
clock setting is erased.
Timer Setting
• The system can switch on to CD,
TUNER, or TAPE 2 mode
automatically at a preset time. It can
serve as an alarm to wake you up.
• Before setting the timer, make sure
the clock is set correctly.
• The timer will always be switched on
once it is set.
• The volume of the timer will
increase from the minimum
level until the volume level
before the set is switched to
standby mode.
1 Press and hold CLOCK/TIMER for
more than two seconds to select
timer mode.
™ "AM 12:00" or "00:00" or the
last timer setting starts flashing
depending on whether you have
selected 12- or 24-hour mode.
™ The TIMER starts flashing.
™ The selected source is lit while
other available sources are
flashing.
2 Press CD, TUNER or TAPE to
select the desired source.
• Before selecting CD or TAPE, make
sure a CD or tape is loaded in the
CD tray or tape deck 2.
3 Press␣ à or á on the system to
set the hour for the timer to start.
4 Press␣ í or ë on the system to
set the minute for the timer to start.
5 Press CLOCK/TIMER to store the
start time.
™ The timer is now set.
™ The
TIMER remains on the display.
• At the preset time, the timer will be
activated.
™ The selected source will be
played.
Notes:
– During timer setting, if no button is
pressed within 90 seconds, the system
will exit timer setting mode
automatically.
– If the source selected is TUNER, the
last tuned frequency will be switched
on.
– If the source selected is CD, playback
will begin with the first track of the
selected disc or program. If the CD
trays are empty, TUNER will be
selected instead.
– If the source selected is TAPE, and if
the preset time is reached during high
speed dubbing, the TUNER will be
selected instead.
– The timer will not activate if a recording
is in progress.
To switch off the TIMER
• Press TIMER ON/OFF on the
remote control.
™ The timer is now switched off.
™ The display will show "CANCEL"
and the TIMER disappears.
To start the TIMER again (for the
same preset time and source)
• Press TIMER ON/OFF on the
remote control.
™ The timer is now on.
™ The
TIMER appears on the display.
pg 01-28/C80/37-Eng 2/16/00, 9:06 AM 24