Philips sensiflex HX2745 - Manual (Page 5)

Preparing the appliance for use
Mounting the base unit to the wall
C
1 Mount the base unit to the wall, using
2 screws (3.5x30mm) and 2 wall plugs (S5)
(not included).
To drill the holes in the right places, you can use
the drilling stencil on the last page of these
directions for use.
Do not allow the base unit to come into contact
with water.
Using the toothbrush
Charging the toothbrush
C
1 Charge the appliance for at least 16 hours
before using it for the first time.
Make sure the appliance is switched off when you
start charging it.
◗ Type HX2745 only: when the battery is being
charged, the green pilot light is on.
Tip: you can put the toothbrush in the base unit
and let it charge continuously.
However, when you first start using the
toothbrush, it is recommended that you use it
until the battery is empty.To do so, use the
toothbrush in the normal way without recharging
it between brushing sessions. Recharge the
ENGLISH
5