Panasonic EY6535 - Manual (Page 9)

— 9 —
Using Quick change chuck
(EY9HX110)
This Quick change chuck is
designed to be used with Pana-
sonic EY6535.
Top collar
: To insert or to
remove bit.
Bottom collar: To attach or to
detach Quick
change chuck.
Use 6.35mm (1/4") hexagonal bits.
To ensure proper securement of the bit, use only
hexagonal bits with 9.25mm (3/8") detent.
CAUTION: Make sure the work environment is
safe. When retracting bit from work
material, Quick change chuck may
detach if subjected to 50kg or more
of pull force. Detachment will be sud-
den. Use care and avoid excessive
force when retracting bit from work
material.
1. Attaching Quick change chuck
Attach the Quick change chuck by pulling the
bottom collar forward and sliding the female
detent on the bottom of the chuck to the
square drive on the body.
Release the bottom collar to make sure the
Quick change chuck is firmly connected to the
body.
2. Inserting the bit
Pull the top collar of the Quick change chuck
forward, then insert the bit.
Release the bottom collar to make sure the bit
is firmly connected to the chuck.
3. Removing the bit
Pull the top collar of the Quick change chuck
forward, then pull the bit.
CAUTION: lmpact mechanism creates heat.
Square drive and accessory may
become very hot and may cause skin
burns. To prevent skin burns, use
work gloves and/or allow heated
parts to cool down before handling.
4. Detaching Quick change chuck
Pull the bottom collar of the Quick change
chuck forward to detach it.
Attaching or removing battery
pack
1. To connect the battery pack:
Insert the battery pack. It snaps into place to
indicate proper connection.
2. To remove the battery pack:
Press the two buttons on the sides of the bat-
tery pack. Slide the battery pack out of the tool
body.
OPERATION
Switch Operation
1. The speed increases with the amount of
depression of the trigger. When beginning
work, depress the trigger slightly to start the
rotation slowly.
2. A feedback electronic controller is used to
give a strong torque even in low speed.
3. The brake operates when the trigger is
released and the motor stops immediately.
Reversing Lever Operation
(Forward ( ), Switch lock, Reverse ( ))
CAUTION: Do not operate reversing lever until
rotation of the spindle comes to a
complete stop. Shifting during rota-
tion of the chuck may damage the
tool.
1. For reverse rotation, set the lever to reverse.
Check the direction of rotation before use.
Top collar
Bottom collar
6.35mm (1/4") 9.25mm (3/8")
1
2
Top Collar
1
2
EY6535.book 9