Plawa Scrivo.1 - Manual (Page 15)

5.2 scrivo.1 driver setting
After installation, an icon will be created in the System Tray as shown in the figure below .
scrivo.1 System Tray logo figure. Open the scrivo.1 Control Center by
clicking scrivo.1 Setting.
Another way to open the scrivo.1 Control Center is to press the hot key (Defalt: F12). Simple
settings can be done here. Choose “Advanced Configuration” for detailed settings.
Speed
_ Mouse Mode – This setting configures acceleration in mouse mode. Acceleration can be
adjusted by moving the slider (Default: Middle)
_ Pen Mode – This setting configures acceleration in pen mode. Acceleration can be adjusted by
moving the slider (Default: 45)
5. scrivo.1 Driver and Software
5.1 Installing scrivo.1 driver and utilities
Caution: Please exit other programs before connecting scrivo.1 or installing scrivo.1 driver
and utilities.
Setup Bluetooth communication pen and receiver before installing scrivo.1 driver. (Use Bluetooth
Dongle CD). Insert the scrivo.1 driver CD into your CD-ROM drive and install the driver after set-
ting up Bluetooth communication.
1) Select your language.
Installation files will be automatically loaded when the CD included is inserted into the CD-ROM
drive. Select your language to install driver and utilities.
.
2) Choosing setup type.
Select installation details and click [Next] to continue.
_ Install scrivo.1 USB driver – USB driver will be installed if selected.
_ Install Utilities – Finger Note TM will be installed if selected.
24 25 28 29
scrivo1_manual_eng_rz_kb2.qxd 06.12.2004 17:40 Uhr Seite 28