Philips ShowView DVD757VR - Manual (Page 9)

9
English
Setting the clock
If the display shows an incorrect time or ' --:-- ', the time and
date must be reset manually.
If a TV channel that transmits TXT/PDC (teletext/PDC) is
stored under programme number 'P01', time/date will automat-
ically be taken from the TXT/PDC information. (SMART
CLOCK)
1 Press VCR, then DISC/VCR MENU.
2 Press K/L to select 'INITIAL SET UP' , then press B.
3 Press K/L to select 'CLOCK' , then press B.
4 Check the time in 'TIME'. If
required, please change the time
with numerical key pads.
5 Check 'DAY', 'MONTH' and 'YEAR'
in the same way.
6 Choose ‘SMART CLOCK’ ON or
OFF with B.
7 To end, press STATUS/EXIT.
TIME --:--
DATE --/--/--
SMART CLOCK [ON]
END=EXIT
Setting the RF out channel
In some reception locations it is possible that a TV channel will
be sent on the same or similar frequency as the DVD/VCR.
Result: As soon as the DVD/VCR is switched on, the reception
quality for this or several other TV channels will decrease.
The following steps will show you how to change the pre-set
'transmission' (RF out channel) frequency on the DVD/VCR.
1 Press VCR, then DISC/VCR MENU.
2 Press K/L to select 'INITIAL SET UP' , then press B.
3 Press K/L to select 'RF OUT' ,
then press B.
4 Press B.
5 Press K/L or numerical key pads
to select a free (not allocated)
channel between channel 22 and 69
in your area.
6 Press B.
7 To end, press STATUS/EXIT.
SELECT K L CHOOSE B
→RF OUT CH 36
END=EXIT
What is RF out channel?
This electronic component in the DVD/VCR allows the device to
transmit audio and video signals via the aerial cable.These signals
can be received on a TV set just like TV channels.
What is RF out channel frequency?
This frequency or channel indicates the channel on which the
audio or video signal is transmitted.
If you cannot get an interference-free picture and sound, switch
the built-in modulator off.
Press L repeatedly until "--" appears next to "RF OUT CH" on
the TV screen.
Then confirm with B. In that case, please connect your VCR to
your TV with a Scart cable.
Setting Up your DVD/VCR
5 Press K/L to select 'MANUAL
TUNING'.Then press B.
6 Press K/L to select 'DECODER'.
7 Press B to select 'ON' (Decoder
switched on).
8 To end, press STATUS/EXIT.
The decoder has now been allocated to this TV channel.
How can I switch off the decoder?
Use B to select 'OFF' (Decoder switched off).
MANUAL TUNING
PROG. P55
CHANNEL 055
→DECODER [OFF]
SKIP [OFF]
SELECT K L CHOOSE B
END=EXIT
Decoder allocation
Some TV channels transmit encoded TV signals which can only
be viewed with a purchased or rented decoder.You can con-
nect such a decoder to this DVD/VCR.The following function
will automatically activate the connected decoder for the
desired TV channel.
1 Switch the TV on. If applicable, select the programme number
for the DVD/VCR operation.
2 Press K/L or numerical key pads to select the TV channel
which you would like to allocate the decoder to.
3 Press DISC/VCR MENU.The main menu will appear.
4 Press K/L to select 'TUNER SET UP'.Then press B.