Polycom TRAPEZE NETWORKS 1725-36060-001 - Manual (Page 8)

Configuration Guide
PN: 1725-36060-001_D.doc 8
# defines a passphrase
set service-profile Voice auth-psk enable
# enables pre-shared key authentication
set service-profile Voice auth-dot1x disable
# disables 802.1x authentication
set service-profile Voice attr vlan-name default
# maps the handsets to the vlan named default
Radio profile commands
Assume you are creating radio profile “voice” for all radios that will
be providing voice services. The following commands are needed to
setup the radio profile for the access points:
set radio-profile voice service-profile vowlan-wpa2
# maps the service profile to the radio profile
set radio-profile voice dtim-interval 3
set radio-profile voice active-scan disable
# prevents the AP from going off-channel to scan
set radio-profile voice auto-tune channel-config disable
# disables dynamic channel tuning for radios in this
profile.
set radio-profile voice qos-mode svp
# qos mode SVP must be set for SVP to be supported
Network topology and MP access point hardware
configuration
The network topology and access point hardware configuration can
be configured using the Mobility System software. Please refer to the
Trapeze Networks Mobility System Software Configuration Quick Start
Guide or the Trapeze Mobility Exchange Installation and Basic
Configuration Guide for more information. Some useful commands are:
To create VLAN “v1” and add port 3 as a member of “v1:”
set vlan 2 name v1 port 3
# 2 is the VLAN ID (must be unique for every VLAN on
the switch)
To create a configuration for a model MP-422 access point that is
directly attached to port 1 of an MX switch:
set port type ap 1 model mp-422 poe enable