Philips AE2380 - Manual (Page 7)

POWER SUPPLY
7
The type plate is located on the bottom of the set.
1 Check whether the voltage as shown on the type plate
corresponds to your local voltage. If it does not, consult your
dealer or service organization.
2 Connect the AC mains lead to the MAINS V~ inlet and to the
wall socket. This switches on the mains supply.
Connecting the set to the mains switches off the battery supply.
Disconnecting the set from the mains has one of the following effects:
• If batteries are inserted:
y The set switches on the battery supply;
or
• If no batteries are inserted:
y flashes and the current time is displayed. After a short
time all settings will be lost.
To disconnect the set from the mains completely, remove the
mains plug from the wall socket.
For users in the U.K.: Please follow the instructions on page 4.
• Open the battery compartment and insert 4 batteries of type
R20, UM1 or D-cells (preferably alkaline).
Notes: – Remove batteries if they are exhausted or if the set is
not going to be used for a long time.
– Old and new or different types of batteries should not be
used in combination.
Batteries contain chemical substances, so they should be
disposed of properly.
• Indication of weak batteries:
y starts flashing.
Batteries (not supplied)
Mains supply
English
This set complies with the radio interference requirements of the
European Community.
AE2380/00.1n eng 28.10.1999 13:23 Uhr Seite 7