Philips SLV4200 EN - Manual (Page 11)

Getting started 11
- Switch on the Video source.
- Take these items:
• Receiver (B)
• Power adapter (E)
• Remote control of the video
source.
- Go to TV2.
1. Connect the receiver to the second
TV (TV2)
Plug the SCART cable of the receiver
(B) into the SCART port of TV2.
2. Connect the power adapter
a. Take the supplied power adapter
(E) to plug the connector into the
DC 9V power connector on the
Receiver (B).
b. Plug the adapter into the power
outlet.
c. The green LED on the front panel
should be on.
Note: if it is not the case, press the ON/
OFF switch on the back of the product.
3. Set the CHANNEL switch to the
same channel number as on the
transmitter (A).
3.4 Enjoy
All the operations listed on 3.1 and 3.3
should have been done.
1. Switch on TV2.
2. Switch on the receiver (B).
3. Select the correct SCART input on
TV2.
4. Point the remote control of the
video source to the receiver (B).
5. Operate the video source with its
remote control.
6. Check if TV2 shows the image of the
video source.
> The receiver is connected
correctly.