Palsonic 3498 User Manual

Page 7

SKIP BUTTON:

FUNCTION:

When CHANNEL SELECTOR button is used to select channels, the channel will be skipped
if they are set to "SKIP" mode. For example: Set 2~7 channels to "SKIP" mode, the
procedure of channel position increasing or decreasing.

OPERATION:

1. Press PSET (PRESET ON/OFF) button to set preset mode.
2. Select a channel by using CHANNEL SELECTOR button.
3. Press "SKIP" button, "SKIP" will be displayed on the screen to indicate that the channel is
at "SKIP" mode.

4. Repeat 2 ~ 3 steps to skip another channel.
5. Press PRESET ON/OFF button to exit preset mode.

SOUND CONTROL:

VOLUME CONTROL

Press the (VOL) button to increase volume; the red block on the screen moves right.
Press the (VOL) button to decrease volume; the red block on the screen moves left.

When there is a phone-call or a visitor, it can temporarily shut off the sound without
affecting the picture.
To resume normal, press the MUTE or VOLUME ( ) button. The previous volume
will be displayed for 4 seconds.

3 SKIP

llllllllllllll

MUTE BUTTON (REMOTE CONTROL UNIT)

1 2 58 59

(REMOTE)

(THE APPLIANCE)

CHANNEL DECREASE

CHANNEL INCREASE

1 2 58 59

SKIP

4. Press PRESET ON/OFF button to exit preset mode.
The searched program station has been memorised at the present channel position,
5. Repeat 1~ 4 steps to search another channel.
NOTE : * If the same channel position is selected during repeat operation, the former
memory will be erased.
* If some channel position is tuned by MANUAL TUNING mode, AFC (automatic
frequency control) function is defeated in this channel position.