beautypg.com

Link wireless telephone accessories, Battery packs, Important – Polycom SpectraLink PTC400 User Manual

Page 11

background image

SpectraLink Corporation

Link Wireless Telephones and Accessories User Guide

Part Number: 72-0075-09-C.doc

Page 10

Link Wireless Telephone Accessories

Battery Packs

Overview The wireless telephone will need to have its Battery Pack (PTS360)

recharged periodically. The Nickel Metal Hydride (NiMH)
rechargeable wireless telephone Battery Pack gives you four hours
of talk time or 80 hours of stand-by time. Stand-by time is when the
phone is turned on, but you are not using it.

Indications of low battery The wireless telephone will notify you when the charge on the

Battery Pack becomes low. If the wireless telephone is in use, the

BATT message will display and you will hear a soft beep through the
earpiece every six seconds. You have two minutes to complete the
call or change the Battery Pack.
The Battery Pack can be changed while the call is still in progress.
Do not press END. Quickly remove the discharged Battery Pack
and replace with a charged Battery Pack, press PWR, and then press
START to resume the call in progress.
If the wireless telephone is idle, you will hear a brief modulated ring
signal and the Low Battery message will display. Your wireless
telephone will not operate until you replace the Battery Pack.
Depending on the charging equipment you have purchased, you will
either place the wireless telephone in a Charging Stand to charge the
Battery Pack, or you will remove the Pack from the wireless
telephone and install it in the Charger.

Caution: Take care not to short the battery contacts on the Battery Pack with

metal objects such as coins, keys or paper clips. Shorting the
contacts can cause permanent damage.

Battery Pack removal and

replacement

To remove the Battery Pack, press down on the oval button above
the Battery Pack on the back of the wireless telephone. Slide the
Pack toward the bottom of the wireless telephone until it stops,
then lift up.
To replace the Battery Pack, first properly align the top of the
Battery Pack with the arrows on the label on the back of the
wireless telephone. Gently press and slide the Pack toward the top
of the wireless telephone until it snaps into place. You should not
have to force it against the wireless telephone.

Important

:

Only use SpectraLink Battery Packs with SpectraLink Wireless

Telephones.
Do not dip the Battery Pack in water or throw into fire.
Do not throw away the Battery Pack with your domestic waste.
Take used Battery Packs to an appropriate collection point for
recycling or send them back to your supplier or servicing agent.