Philips MCD300 - Manual (Page 32)

66
English
Setting the clock
1
In Standby mode, press and hold CLOCK on
the remote until the time flashes on the display.
➜
”
SET CLOCK” is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the hours.
3
Press CLOCK to confirm.
➜ The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME +/- on the remote to set
the minutes.
5
Press CLOCK again to confirm the clock
setting.
Notes:
– This system only supports 24-hour mode.
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 30 seconds.
Setting sleep/wake-up timer
Sleep timer setting
In power-on mode, the sleep setting enables
the system to switch to standby mode
automatically at a preset time.
Clock/Timer
1
In power-on mode, press SLEEP/TIMER on
the remote repeatedly to select a preset time.
➜
The selections are as follows (time in
minutes):
00
➜ 10 ➜ 20 ➜ 30 ➜ 40 ➜ 50 ➜ 60 ➜ 70
➜ 80 ➜ 90 ➜ 00
2
When you reach the desired length of time, stop
pressing SLEEP/TIMER.
➜ When sleep function is activated, is
displayed.
To deactivate the sleep timer
● Press SLEEP/TIMER repeatedly until “ 00” is
displayed, or press STANDBY ONB (B on
the remote).
➜ When sleep function is deactivated, is
disappears on the display.
Wake-up timer setting
In standby mode, the timer setting enables
the system to switch on automatically at a set
time.
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
1
In standby mode, press and hold SLEEP/
TIMER until the time flashes on the display.
➜ ” SET TIME” is displayed briefly. Then, the
hour digits flash on the display screen.
2
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME -/+ on the remote to set
the hours.
3
Press SLEEP/TIMER to confirm.
➜
The minute digits flash on the display screen.
4
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME -/+ on the remote to set
the minutes.
5
Press SLEEP/TIMER to confirm the time
setting.
➜
”
OFF” flashes on the display screen.
6
Turn VOLUME -/+ clockwise or anticlockwise
or press VOLUME -/+ on the remote to select
“ON”.
➜
icon appears on the display screen.
To deactivate the timer
● Select “OFF” at Step 6.
p038-p071_MCD300_Eng 2005.11.3, 16:34 66