PACKARD BELL LJ61 - Manual (Page 54)

44 Chapter 3
General Information
Pre-disassembly Instructions
Before proceeding with the disassembly procedure, make sure that you do the following:
1. Turn off the power to the system and all peripherals.
2. Unplug the AC adapter and all power and signal cables from the system.
3. Place the system on a flat, stable surface.
4. Remove the battery pack.
Disassembly Process
IMPORTANT:The LCD Module cannot be disassembled outside of factory conditions. If any part of the LCD
Module is faulty, such as the camera, antenna or LCD panel, the whole module must be replaced.
The disassembly process is divided into the following stages:
• External module disassembly
• Main unit disassembly
The flowcharts provided in the succeeding disassembly sections illustrate the entire disassembly sequence.
Observe the order of the sequence to avoid damage to any of the hardware components. For example, if you
want to remove the mainboard, you must first remove the keyboard, then disassemble the inside assembly
frame in that order.
Main Screw List
Screw Quantity Part Number
M2.45D 8.0L K 5.5D 0.8T ZKNL 14 86.WBF02.001
M2.5D 5L K 5.5D ZK NL + CR3 23 86.WBF02.010
M2.46D 3.0L K 5.5D 0.8T ZKNL 3 86.WBF02.002
M1.98D 3.0L K 4.6D 0.8T ZKNL 20 86.WBF02.003
M3.0D 3.0L K 4.9D NI 8 86.WBF02.005
M2D 4.0L K 4.6D NI NL 2 86.WBF02.007
ASSY THML SPRING 4 86.WBF02.009