beautypg.com

Installation, Din rear-mount (method b) – PYLE Audio PLCD69MP User Manual

Page 4

background image

4

INSTALLATION

Removing the unit

1. Frame
2. Release Frame Key

Insert the release frame key into the
groove at the right side of the frame,
then prize out to remove the frame.
(You can also use the key to remove
the frame from the left side.)

3. Release Unit Key

After releasing the frame, insert the
release unit keys supplied with the
accessory into the grooves at both
sides of the unit as shown in figure
until they click. Pulling the keys
makes it possible to remove the unit
from the dashboard.

DIN REAR-MOUNT (Method B)

1. Factory-installed radio bracket
2. Car radio mounting bracket
3. Screw
4. After aligning the car radio mounting

bracket with the factory-installed radio
bracket, tighten the screws (M5x4mm)
at 2 places on each side.

5. When fixing factory-installed radio

bracket with the screws, use a
standard-tipped screwdriver to pry the
tabs of the car radio mounting bracket
to make them fit into the holes in the
factory-installed radio bracket.

6. Movable panel frame

6

4

1

2

3

5

Tab

1

3

2